Filters in different make holders....

Bobsyeruncle

Bobsyeruncle

Suspended / Banned
Messages
17,422
Name
Bob
Edit My Images
Yes
I've got a firecrest square filter holder. The filters are 2mm thick.
Was looking for a less expensive square nd 6 stop filter.
SRB do one for £30 but it's 2.3mm thick.
Anyone know if it's likely to fit?
Cheers.

This is the holder that I have

HT85AMH.jpg
 
Last edited:
I'm sure you could easily make shims to space the holders out if required. A soda can used to be made from aluminum about .3mm thick (probably thinner these days). Just layers of tape would probably do it.
 
sk66 said:
I'm sure you could easily make shims to space the holders out if required. A soda can used to be made from aluminum about .3mm thick (probably thinner these days). Just layers of tape would probably do it.
Click to expand...
Thanks.

I'm thinking if I loosen the screws on the holder I might be able to squeeze in the 2.3mm filter instead of the 2mm filters without needing shims?
 
Last edited:
Standard 80gsm copier paper folded in two measures 0.25mm to give you an idea.
 
Thanks guys.
I had a look at the holder last night.
My current 2mm filters just slide in without me touching the screws on the holder.
If I loosen the screws a 2.3mm will fit, I'll just need to loosen the screws, insert filter then tighten the screws.
No big deal I suppose.
 
You must log in or register to reply here.
Back
Top