sync cable sizing

[ruffdog64]

I have 2 lencarta smartflash 200s and a hahnel rx and tx for remote controlling of the flashes ,the issue is the synx port on the lencarts 200s is larger than the lead supplied with hahnels is there any other cables available with a different size on each end,Thanks Harvey

 

[Phil V]

You should be able to pick up adaptors, look up jack plug adaptors.
Here

 

[ruffdog64]

Thanks Phil, i have looked but the sync port on the flash head isn`t much larger the adaptors i`ve seen so far seem 1/4" ish

 

[Phil V]

Thanks Phil, i have looked but the sync port on the flash head isn`t much larger the adaptors i`ve seen so far seem 1/4" ish

So what size is the plug on the trigger?
Are the Smartflash the new ones?

 

[simonbarker]

I think both versions of the Smartflash use a 3.5mm socket but no idea what the Hahnel uses.

 

[HoppyUK]

Thanks Phil, i have looked but the sync port on the flash head isn`t much larger the adaptors i`ve seen so far seem 1/4" ish

I'd be surprised if it was anything but 3.5mm to 1/4in that's needed.

 

[ruffdog64]

the size of the plug on the hahnel is slightly smaller than the one needed for the lencarta, i have found one in my office but need another for the other one now

 

[Phil V]

One of these?

 

[ruffdog64]

One of these?

Yes and ordered ,thanks Phil