Sharing my new homemade bounce card thingymajig...

With that much bounced light, it may only be a little different than using the flash without one. Watch the ABBC/David Gregg version, the foamy one can be shortened, to give less light at the front if needed.
 
Yes, probably a bit big, but you can vary the bounce-fill ratio by zooming the flash head - longer setting increases the bounce and reduces the fill. Also, tilting the head down a bit will increase the amount of fill by a lot.
 
NigelPaul said:
With that much bounced light, it may only be a little different than using the flash without one. Watch the ABBC/David Gregg version, the foamy one can be shortened, to give less light at the front if needed.
Click to expand...

Thanks for the advice, I can slide it further down the flash head, do you think it would be worth trimming it a little?


chip said:
Will there be a Nikon version? :D
Click to expand...

Of course.....NOT!
 
kennysarmy said:
Will post photos of the smaller one I make later.....
Click to expand...

Also worth noting the shape of it will also dictate the shape and size of the catch lights...;)

hhmmmmm that has me thinking...:thinking:
 
Last edited:
NigelPaul said:
With that much bounced light, it may only be a little different than using the flash without one. Watch the ABBC/David Gregg version, the foamy one can be shortened, to give less light at the front if needed.
Click to expand...

Have you seen the size of the Metz 45 one? it's huge.
 
You must log in or register to reply here.
Back
Top