Dell Mini 10 and Eye One Calibration

[TurnipFarmer]

I have installed the Imatch 3 software on my Mini 10. I have run into a problem that I cannot start the calibration process as the button on the software is not viewable on the software and hence can't start it.

Anybody else had this problem with their Mini 10 and eye one (imatch software)??

 

[JasonRS]

That usually means it can't see the sensor.

Or do you mean it's off the screen, so you can't see it?

 

[TurnipFarmer]

it can see the sensor, says it at the top of the screen. I mean its off the screen but I cannot pull it up/down to click the button.

 

[scarey]

Is the button the default selection? If so pressing 'Enter' on the keyboard should do it.

 

[TurnipFarmer]

I am not sure, will have to check on my main computer but I also think I have tried that too.