Canon Mt24ex problem

[cruso]

Help needed Hi as anyone had any problems with the canon twin flash ? As one of the flashes as stopped working or am I missing something with the settings I have replaced the tube and it is still not working before I send it in for repair

 

[Gaz J]

Help needed Hi as anyone had any problems with the canon twin flash ? As one of the flashes as stopped working or am I missing something with the settings I have replaced the tube and it is still not working before I send it in for repair

I'm sure you've already checked these Kevin.

Ratio controller not set completely to one side.

C FN 5 set to 0

Ratio set to AB not ABC.

Other than that, can't help I'm sorry.

 

[cruso]

Thanks Gary yes checked it is their a way to factory reset these?

 

[Canon Bob]

I don't think that you'd learn too much by opening it up, Kevin. The MT-24 has a single capacitor and charging circuit (clearly that's operating) and the leads from the flash portion of each head are very much sealed in place making swapping a tiresome process unless you revert to cutting and soldering. Each head has its own coil and semiconductor but everything else is on a common PCB.

If you do decide to delve inside, I can give you details of the positions of the case clips once the screws have been removed but I suspect it's probably a job for Canon.

Bob