How to wallmount A1 print?

[adam*]

Hi

I have a couple of A1 foamcore mounted prints which i'd like to put up on my wall, also a couple of A3's. I tried using the sticky dots (loads of them) but both prints fell off after a few days (seemed stuck on fine at first) - thankfully only minor dints in them. Does anybody have a proper secure way to get them wall mounted.

Cheers

Adam

 

[menthel]

Do it the manly way, use a nailgun!

 

[adam*]

That's not going to work!

 

[Ozei]

Velcro heavy duty stick on tape.

 

[adam*]

http://www.amazon.co.uk/Nails-Strip...ef=sr_1_1?s=diy&ie=UTF8&qid=1327416817&sr=1-1 been told about this stuff, will apparently make a mess when removing. I'm guessing anything strong enough will?

 

[Ozei]

http://www.amazon.co.uk/Nails-Strip...ef=sr_1_1?s=diy&ie=UTF8&qid=1327416817&sr=1-1 been told about this stuff, will apparently make a mess when removing. I'm guessing anything strong enough will?

I should think that would rip the walls to bits.

 

[Ozei]

Velcro heavy duty stick on tape.

This would make less mess.

http://www.red17.co.uk/catalogue/packaging/velcro-range/velcro-heavy-duty-giant-coins

 

[dcash29]

No nails

 

[Susane]

3m Command picture strips.

Available at Asda & B&Q.

 

[rhody]

You can buy mounting rings in most hardware or art stores.

Look for the ones with a flat mounting area which have a little barb that goes into the back of the foam board.

Alternatively, seek out some gummed cloth hangers - ideal for light weight foamboard and card

Bob's your uncle! (I've never really understood that expression )

Try asking here - a very good supplier

http://www.lionpic.co.uk/hardware-supplies/frame-hardware/d-rings-hangers/plastic-adhesive-hangers.aspx

Happy hanging!