Recent content by Ershin

might help if you post the picture up? you might luck out and be able to mask it with channels, or if whoever is sitting doesent have blonde hair you might get away with a luma-key

sorry its taken me so long to reply - i got sidetracked and then i sort of forgot the task of writing individual replies to everyone is a little daunting though, so il just say thanks very much to everyone, youve all been very helpful :) unfortunately its still either way since they both seem...

my fiance and i recently bought a meter by a meter-ish sheet of it from trent plastics, i emailed a quote on, because i needed 1000x1009mm rather than 1x1m and they put the 9 on without changing the price - but they do completely custom sizes as well, and i think our piece cost us roughly £30...

im looking into getting a couple of lower end monoblocs, so, either the gemini or the d-lite-it, in either 200 or 400 W/s id like to hear from anyone owning either of the two, regarding subjective opinions after having used them, since while i have the specs, there are always going to be...

thanks ^_^

looks like it hit the front corner of the prism to me, or very close to that

oh, actually, if your still up for it, could you get me the length from the hinge at the rear of the flash head to the front element? thatd help with riser tolerances //edit and the total length please >.> sorry, i just realized those extra bits would be helpful. my memory is terrible, honestly

alright, so i figure tolerances need to vary from 3x6 to 5x8, assuming im not worried about losing the ability to use vivitars in exchange for a better fit il try and post it up when its done, if anyones interested - might be a while though, im taking pains to make sure its modular and what...

awesome, thats very helpful

no, was about to say, a hell of a lot bigger than the nikon units i measured (though admittedly there old units) lol

i need measurements of the flash end of speedlights (length and width), but i only have a sb-26 and sb-28 if anyone has any others (nikon, canon or any other type) id be grateful if you could post the measurements rounded up to the nearest half centimeter, noting the speedlight im in the...

awesome, thanks everyone

just realized cellophane might be a better word than plastic

does anyone know where i could find a supply of various sizes of (ideally peel-and-stick) plastic packaging for mounted prints? ideally without a huge minimum order quantity?

had a quick google for you, but i couldent find where the guy said it. pretty sure it was 15** though, so you might be in luck. i dunno what the price difference is exactly, but you could always check the fit, i guess